Anyload EB200 Instrukcja obsługi - Strona 5

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Wagi Anyload EB200. Anyload EB200 11 stron. Precision scales

4. PREPARATION/INSTALLATION

4.1 Installing batteries/Connecting the AC adaptor

Batteries

Battery

compartment

Battery compartment cover

AC adapter (optional)

AC adaptor

socket

4.2 Setting up the scale/balance

Avoid placing the scale/balance in direct sunlight, that may cause discoloration or malfunctions.

Place your scale/balance on a firm weighing table so that the scale/balance is level. (The

scale/balance will not perform accurately when it is not level.)

Place the scale/balance on the firm surface that is flat and level for an accurate weighing.

Whenever possible, please allow the balance to warm up for 10 minutes after first turning to

power on, so that the balance will function properly and accurately.

EEEE:

Overload

Low battery

Calibration may be required before weighing.

Read "CALIBRATION" first and if necessary, calibrate your scale/balance for accurate

weighing.

4 |

A N Y L O A D E B 1 0 0 / E B 2 0 0 M a n u a l ( V 0 1 1 6 )

Remove the battery compartment

cover and insert six batteries(R6P/LR6

/AA size) into the battery compartment,

taking extreme care that the polarities

plus and minus is observed.

R6P/LR6/AA size

Dry batteries.

(batteries are not included)

Plug the AC adapter to the AC

adapter socket on the side.

The AC input requirement could

be 110,120,220,230 or 240Volts

(50/60Hz) depending on the area

where used, so please verify that

the adaptor is correct

△ ! CAUTION