Concierge ACMGWM10 Instrukcje instalacji - Strona 2

Przeglądaj online lub pobierz pdf Instrukcje instalacji dla Stojaki i stojaki Concierge ACMGWM10. Concierge ACMGWM10 4 stron. 10 window mount bracket

The following instructions should be used to install the

Concierge Displays ACMGWM10 window mount bracket.

Preparation and Notes

Ensure that there is sufficient access

to the top part of the window frame

where the bracket is to be mounted.

There will be the need to feed down

DC power cable and or UTP cable.

Step 1

Determine the height that the bracket is

to be mounted. Place the bracket in the

desired location and with a marker, mark

the window sealant where the bracket

comes in contact. Using a utility knife

cut out all of the silicone that you have

marked to allow the bracket to sit flush

into the corner of the window frame.

Step 2

Remove the VESA side of the panel adaptor bracket by removing the 2 x M5 phillips screws

from the bottom and sliding it up. Remove the bracket side of the panel adaptor bracket by

removing the 2 x M6 Nyloc nuts using a 10mm nut driver. This is to allow access for drilling

and fastening of the bracket to the window frame.

Concierge Displays Pty Ltd

Tools required

• Isopropyl wipe

• Fine tip permanent marker

• Utility knife

• Battery powered drill/driver

• 8mm drill bit

• Philips drive bit

• 3mm Hex drive

• 10mm nut drive

• No. 2 handheld phillips screw driver