2connect CAM-FT6 Podręcznik użytkownika - Strona 3

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Akcesoria samochodowe 2connect CAM-FT6. 2connect CAM-FT6 4 stron. 2-in-1 reversing camera/brake light solution with wireless controller

Drukuj stronę

Connecting CAN-Bus Wiring

FRONT OF OBD CONNECTOR

USING THE WIRELESS CONTROLLER

Start-Up

The wireless controller included in the kit can be used to change the viewing mode of the camera, as

well as adjust key parameters for each viewing mode.

To bring up the HUD menu, put

the vehicle into reverse gear and

press A.

Note: The HUD menu will time-out

after 3 seconds to allow an unin-

hibited view of the camera image.

Press the A button to bring the HUD

menu back onto the screen

The currently selected viewing mode is displayed by the icon in the centre of the HUD menu. This will

default to Driving/Rear-View mode, or to Reversing mode when in reverse gear.

To change the camera mode, whilst the vehicle is in reverse gear, press B or C to cycle through the

Reversing, Wide Angle and Birds-Eye viewing modes.

Viewing Modes

Reversing

(Select from HUD Menu)

Switch to

Wide Angle

www.connects2.com

Locate the vehicle's OBD port and unscrew/

remove the female connector.

On the reverse of the connector (the side

where wiring enters it), connect the CAN

+ (blue) and CAN - (white) wires from the

harness to the locations specified in the

diagram (Pins 1 and 9).

Currently selected view

Driving/Rear-View

Connects2Vision

Go to Settings

Switch to

Birds-eye

HUD Menu

(Default view when not in reverse)