Dudek Techno Podręcznik użytkownika - Strona 3

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Akcesoria Dudek Techno. Dudek Techno 19 stron. Light harness with a pod

3. Speedbar

Speedbar lines must be led through the pulleys (under the seatplate and on the back support). Then put it through the

slits in the pod and fix a stoper, accompanied by speedsystem clip. Connect the speedbar to the footrest with a rubber

band. Find the best length of the rubber, so that speedbar will be easily accessible in flight. In order to adjust the

whole system you have to sit in the harness while it is hanged by the paraglider's risers. At full speedbar the pulleys

on the risers should touch. When necessary, adjust the lines later according to your experience in flight.

Do not adjust the speedsystem lines while in flight.

The Techno harness has a frontcontainer to hold the rescue chute.

It is fixed to the chest strap with a central, well-visible release handle.

Short v-strap is integrated with the chest-strap and together clipped into

the main carabiners.

Connect the v-strap to the rescue chute riser. Tighten up the connection and cover it with a neoprene part attached to

the frontcontainer.

! !

If the rescue chute riser is finished with a big loop, make sure that the connection is placed exactly in the

middle of the loop. After tightening the loop must be evenly loaded, and the connection place must not

move.

Speedsystem lines

Speedbar

Rubber connecting speedbar with

the footrest