Anyware Instruments Moodulator Podręcznik użytkownika - Strona 13

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Syntezator Anyware Instruments Moodulator. Anyware Instruments Moodulator 19 stron.

Mod env (Modulation Envelope) is a multi function envelope, and it´s the main element of the Modulation Control

section (see below). It´s an AD envelope, with looping capabilities, and it´s level can also be modulated.

ATTACK :

Defines the Attack time, from 1ms to 10 secs.

DECAY :

Defines the Decay time, from 1 ms to 10 secs.

LEVEL (switch)

FULL:

it works as normal, with it´s full level all the time.

Wheel

: it´s level is controlled by the mod wheel (CC1).

If you´re using the Mod env for, ie, hard sync, you can control the hard sync depth with the mod wheel.

TRIGGER (switch)

Note: this the normal mode, the env is trigger by a note on event, or a gate signal at the Gate input.

LFO:

Mod env is triggered by the LFO.

-----------

MODE

AD:

Normal mode, no looping.

LOOP:

A gated loop mode, which means it´ll loop as long as a gate is ON.

LFO:

It´s always looping, no matter the gate state.

EXPO / LIN (switch):

OSC1 fm:

controls the amount of frequency modulation to the oscillator 1.

OSC2 fm:

controls the amount of frequency modulation to the oscillator 1.

Cutoff:

controls the amount of cutoff modulation to the VCF.

(tip: if you combine this with the Filter env, you can get nice complex envelope shapes)

OSC2 PWM:

controls the amount of pulse width of oscillator 2.

The MOD Envelope

set the Exponential or Linear mode of all 3 envelope´s.

MOD ENV AMOUNT Section