Anywave ATSC 60W Skrócona instrukcja obsługi - Strona 9

Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Nadajnik Anywave ATSC 60W. Anywave ATSC 60W 17 stron.

5 Initial Turn On

Please locate and have handy for reference a copy of your 60W TX Factory Test

Report as well as the 60W TX Quick Start Guide, and PA-U01-C-FA PA and

Exciter User Manuals.

1. With all equipment turned OFF, please make the cable connections according

to the System Interconnect Diagram of section 4. Make sure the BPF or PA

output is properly connected to your Antenna feed or a suitable station load

before proceeding further.

2. Turn ON the Exciter via its rear panel AC switch.

3. Check Exciter settings. Check the operating Frequency of the Exciter by

navigating to the Exciter FREQ submenu (simultaneously press Left and Right

buttons)

Check the Exciter drive level is set to -25dBm by navigating to the Exciter

RF submenu (from above, press ESC button then enter the RF submenu).

(Please refer to your Exciter User Manual for help with detailed operation of

the Exciter).

4. Turn the 60W PA ON via the PA rear panel breaker, which should turn BLUE

when ON.

5. The built-in FWD and REF power metering in your 60W TX has already been

calibrated at the factory. The Exciter PAC submenu contains the System

Forward and Reflected power meter readings PA_Fwd and PA_Ref. Visit the

ACT-PAU01-QSG-DOC-V1.1, 06/26/2018

ATSC 60W Quick Start Guide

Page 9 of 17