Anywhere WEBWHIP WIFI-1 Podręcznik użytkownika - Strona 5
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Przedłużacz Anywhere WEBWHIP WIFI-1. Anywhere WEBWHIP WIFI-1 16 stron. Long-range wi-fi receiver
Quick
Install
Guide
Warning: Do not use this product in any location that can be submerged by water.
Power supply:
Use the AC adapter for wall supply or the DC
power cord to connect directly to 12V fused
accessory panel.
Note: You may need a travel adapter if being used in any country other than the US.
The product comes standard with a US plug.
Page 4
Mount the L-bracket onto the mounting surface using one of the
three options listed in the "Mounting Options" section of this manual.
Assemble the antenna onto the L-bracket using the hex-nut. Tighten
the hex-nut using pliers/ wrench.
Assemble the Wi-Fi Radio onto the antenna from the bottom by
screwing on its Coupling Ring onto the threads of the antenna.
Route the Ethernet cable through your boat, vehicle, or cabin such
that one end is available at the WebWhip and the other end is
available near your computer or wireless router.
Take off the end cap and pass the one end of the cable through the
hole on the cap.
Plug in the cable into the socket enclosed under the end cap.
Close endcap and ensure that the rubber grommet is inserted to seal
the hole through which the cable exits the device.
7
At the other end, connect the Ethernet cable to the Ethernet socket
on the power injector.
8
Using the power cord, plug power injector into the power supply.
9
Connect the Ethernet connector of the power injector to a the
ethernet port of a laptop, wireless router or access point.
10
If the WebWhip is connected to a wireless router or access point,
follow manufacturer instructions to set up a Wi-Fi hotspot.
11
Ethernet cable
INSTALLATION
Power injector (PoE)
WIFI-1 / WebWhip
Power supply
Ethernet port
AC power
DC power
Wi-Fi Receiver Kit
™