ANZ POS Mobile Plus Skrócona instrukcja obsługi - Strona 3

Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Terminale dotykowe ANZ POS Mobile Plus. ANZ POS Mobile Plus 8 stron.

MAIL / TELEPHONE ORDER TRANSACTIONS (MOTO)

Enter the purchase details through your POS until the EFTPOS screen displays "PRESENT CARD AMT".

Press <Func>.

Key in the Card Number and press <ENTER>.

Key in the Expiry Date and press <ENTER>.

Select Type MOTO by pressing <

Select the order type. For MAIL ORDERS press < — > or for TELEPHONE ORDERS press <

Press the < — > key for Single transaction, <

If the terminal prompts for a Verification Number, key in the 3 digit verification number located on the back of

the card and press <ENTER>.

Transaction will be authorised and a receipt will be printed.

SETTLEMENT

ANZ Worldline Payment Solutions offers same day settlement, every day.*

* For ANZ business account holders, funds are available on the same day for online transactions, processed through

the terminal and settled before 09:00 pm (AEST). For non-ANZ business account holders, for online transactions

processed through the terminal, ANZ Worldline Payment Solutions will transfer the funds to the merchant's bank on

the following business day and the availability of the funds will be determined by the merchant's bank. For

transactions processed offline or via Paper Merchant Vouchers, these settlement times do not apply.

CLEARING ELECTRONIC FALL BACK (EFB)TRANSACTIONS

If you see an asterisk (*) displayed on your screen, please follow the process below to clear stored

transactions:

To clear EFB transactions press <FUNC> 8, 8, <ENTER> <ENTER> <ENTER>.

Terminal will clear all EFB transactions.

Note: The terminal will clear EFB transactions automatically after being idle for a certain amount of time.

The terminal will prompt if Authorisation is required for EFB transactions. Obtain Authorisation by contacting

the relevant Authorisation Centre.

REPLACEMENT TERMINAL INSTALLATION TIPS

Please only follow the instructions when installing replacement terminals. This guide should not be used

for new terminal installation. Contact your IT support team or ANZ Worldline Payment Solutions for new

installation instructions.

Plug in the terminal using one of the two connections below

USB CABLE

Once the terminal is connected, press <Func> 1, 1, 1, 1, 2, 2, 2, 7 <ENTER> <ENTER>.

Press the <

> or <

Once the correct connection is selected, press <ENTER>, press <ENTER> again under Protocol.

> for Instalment or <

> buttons to cycle between the COM0(serial) and USB connections.

> for Recurring transaction.

SERIAL CABLE