Duerkopp Adler 745-26 Instrukcja instalacji - Strona 4

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Maszyna do szycia Duerkopp Adler 745-26. Duerkopp Adler 745-26 18 stron.

2.2 Movement

The sewing-machine chassis is fitted with four castors for movement

around the plant.

Attention!

Prior to commissioning the sewing machine the sound absorbers 3 (in

the tools and hardware set) must be fitted to the four chassis supports.

Reverse the castors so that the machine is motionless and stable.

–

To move the machine extend the four castors by turning the

adjusting screws 2 to the left.

The chassis supports must have enough free floor space to allow

for movement.

–

After moving the sewing machine, lower it by turning the

adjustment screws 2 to the right.

All four chassis supports must be firmly on the floor.

Working height can be adjusted between 87 and 110 cm (measured to

the top of the table plate).

It is set to the minimum of 87 cm prior to despatch.

–

Undo locking screws 1 on all four spars of the chassis.

–

Adjust the base plate to the required working height.

To prevent the base plate from tilting, pull it out (or push it in) by

the same amount on both sides.

–

Tighten locking screws 1.