Abtus ABT4050 Instrukcja obsługi - Strona 3
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Przyrządy pomiarowe Abtus ABT4050. Abtus ABT4050 4 stron. Collapsible platform gauge
3.0 General Description
The Abtus ABT4050 Platform Gauge has been designed to be used from the platform by a single operator-offering
the possibility of platform measurement without track possession. The gauge is primarily used as an inspector's
tool in assessing the positioning of station platforms. If used correctly, the Platform gauge can measure the offset
and height of a platform, relevant to the top of the rails to ± 2mm. There is a great flexibility with the type of rails
on which it can be used due to its construction from non-conductive GRP (glass reinforced plastic) and nylon 6.
The GRP and Nylon construction is lightweight and electrically non-conductive and the tool may be folded under a
minute, to a compact size for carrying and storage.
4.0 Use of Gauge
The unique open frame allows the operator to lower the gauge onto the track from the platform and move it quickly
in the event of a passing train. Height and offset measurements are made by means of a sprung measurement
stick. A self-positioning foot adjusts to any rail type, while the opposite rail is referenced to account the train tilt.
4.1
Assembling the gauge
Un-clip the straps from the gauge and position the two connecting knobs in slots on the main foot. These are to
be tightened so that the head of the screw fits flush in the countersunk holes in the nylon profiles.
4.2
Positioning the gauge
The optimum position for holding the gauge is on the end of the protruding pole, near to the clip. From this position
the gauge can then be lowered onto the rail (the 'claw foot' locating on the closest rail, the flat foot on the furthest
rail). The self-positioning foot will adjust to any rail, side-cut etc. The opposite rail is referenced to give cant
adjustment.
4.3
Taking measurements
The offset of the platform from the track is measured in both horizontal and vertical planes on a self-positioning
nylon arm. It is important to allow the arm to find its own position on the platform, however some minor adjustment
may be required to maintain an accurate reading of ±2mm.
Due to the nature of the tool, it is possible to force the measuring arm away from its optimum measuring position,
by excessive pushing or pulling. Extra care must therefore be taken by the operator to avoid the culmination of
misleading readings.
5.0 Maintenance
Care should be taken to avoid dirt entering the various tool mechanisms, as this may reduce effectiveness. The
tool may be cleaned by wiping with a damp cloth. Thinners must not be used.