Abtus ABT4650 RouteScan Instrukcja obsługi - Strona 16

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Przyrządy pomiarowe Abtus ABT4650 RouteScan. Abtus ABT4650 RouteScan 17 stron.

9.0 Trouble shooter

Tips for Good Recording

9.1

The ABT4650 is a very accurate piece of equipment – many of the parameters

that it measures rely on extremely sensitive sensors. While every reasonable

effort has been made to make it 'railway proof', users should treat it with extreme

care.

No Power

9.2

Check that all the batteries are fully charged. The RouteScan takes approximately

4hours to charge and the Control Unit takes approximately 2hours.

Cannot Connect

9.3

The connection between the Control Unit and the RouteScan is via Bluetooth.

Obstacles such as metal and water (the human body is mostly water!) can

degrade wireless signals – ensure that nothing is restricting the signal.

Ensure that all batteries are fully charged (see Section 4.1 for more information

on the batteries).

Cannot Save Data

9.4

Check that the SD Card is not set to 'Read-Only' (the small white switch on the

side of the card).

Measurement Takes a Long Time

9.5

The time taken to perform a point measurement is dependant on surface quality.

Surfaces that are too shiny or too dull will effect the measurement time. On

standard brickwork or masonry, RouteScan can complete up to 240

measurements per second.

RouteScan has been benchmarked on the same calibration surface as is used for

calibrating the Structure Gauging Train in the UK and has been proven to work

reliably.

When using RouteScan to measure Gauge and SE in Single Point mode; ensure

that the laser is pointing at a near-by surface to minimise measurement time.

4650-1 Issue 04