Addictive audio BOOST Series Instrukcja obsługi i instalacji - Strona 9
Przeglądaj online lub pobierz pdf Instrukcja obsługi i instalacji dla Wzmacniacz Addictive audio BOOST Series. Addictive audio BOOST Series 15 stron.
5. Input Gain/Level Control *NOT A VOLUME KNOB*
This allows for the adjustment of the gain of both channels to match the
output level of the source unit. In addition, it allows adjustment from 0.2V
to 6.0V.
6. Subsonic Filter
Control the high pass crossover point for the speaker outputs to eliminate
ultra low frequencies. This crossover is always on with a -12dB per octave
slope and adjustable from 15-60Hz. This filter is used mainly in ported
applications, to protect the subwoofers from excessive excursion below
the port tuned frequency.
enclosures, but can still be used to help protect the subwoofer system.
7. Auto-Start
When using high-level inputs turn this feature to "Auto-Start High-Level"
and the amplifier will turn on via signal sense rather than having to install a remote
(REM) turn on wire. If installing RCA input cables, turn this feature to "Head Unit
Remote" and install remote turn on cable to the REM input.
8. Bass Boost
This allows the ability to Boost low frequency response
9. Low Pass Filter
This controls the low pass crossover point for the speaker outputs. This
crossover, when selected, will attenuate the frequencies above the
crossover point with an adjustable slope of -12dB or -24dB per octave
(See #10) The crossover point is adjustable from 50-300Hz. This filter
reduces unwanted upper frequencies
subwoofer(s).
10. Low Pass Slope
Choose between -12dB or -24dB per octave slope for the Low Pass circuit.
The steeper the slope (higher the number) the quicker the notes
above/below the set point of #9 above fade away.
Not necessary when dealing with sealed
from being played through the
9
up to +18dB.
(45Hz)