Cascade Rescue CRC-HRB-SS1 Specyfikacja i instrukcja obsługi - Strona 5

Przeglądaj online lub pobierz pdf Specyfikacja i instrukcja obsługi dla Sprzęt bezpieczeństwa Cascade Rescue CRC-HRB-SS1. Cascade Rescue CRC-HRB-SS1 6 stron. Stableseat aerial rescue vest

Drukuj stronę

H. Inspections

I. Inspect before and after every use to ensure the ARV is in serviceable condition.

2. Inspect product label for legibility of serial number, warnings and use instructions.

3. Inspect storage bag, webbing and straps for wear, tears, cuts, frayed edges, or other

damage. Inspect for UV damage.

4. Inspect all structural stitching (different color thread) for abrasion, wear, cuts or

UV damage.

5. Inspect steel lifting rings and buckles for wear, deformation, cracks, etc.

6. Inspect ARV after any period of storage greater than 30 days.

See inspection form on page 11.

IMPORTANT: Discontinue use of the ARV, remove from service, and contact Cascade Rescue if

inspection reveals any doubt about the safety or serviceability of the device.

Contact Cascade Rescue: +1 208-263-2484 or [email protected]

I. Product Care

Cleaning and disinfection

1. The NFPA standard for cleaning rescue gear of blood borne pathogens calls for a solution

of 60 ml of household bleach for every 4 liters of tap water or 1/4 cup per gallon. Soak ARV

for 10 minutes and then thoroughly rinse off. Alcohol can be used to speed drying.

IMPORTANT! Thoroughly rinse the ARV to ensure the bleach solution doesn't damage the

material over long term contact.

2. Quarantine the ARV for 72 hours.

IMPORTANT! Cleaning will reduce the risk of contamination but 100% disinfection cannot be

guaranteed.

5406 Cascade Rescue Stable Seat Aerial Rescue Vest_10.22_FINAL.indd 8-9

Aerial Rescue Vest

I. Product Care - Loading into Carrying Bag

Loading into carrying bag

IMPORTANT! To ensure the ARV is always ready and configured correctly, it is crucial the ARB

is stowed properly after every use.

1. Place the ARV on a clean flat surface

and open it up as shown.

2. Fold the tail loop in. Pull the two

steel lifting rings together so the

magnets engage.

Magnets

3. Fold in half again by bringing the fold

toward the steel lifting rings.

Head

4. Start at foot end and roll tightly

toward head.

Aerial Rescue Vest

Foot

9/27/2022 10:54:43 AM