Addictive audio 5.2 Instrukcja obsługi - Strona 7
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Wzmacniacz samochodowy Addictive audio 5.2. Addictive audio 5.2 13 stron. Stereo/mono bridgeable high power car amplifier
Drukuj stronęWIRING CONNECTIONS
CAUTION:
AS A PRECAUTION, IT IS ADVISABLE TO DISCONNECT THE VEHICLE'S BATTERY
BEFORE MAKING CONNECTION TO THE +12 VOLT SUPPLY WIRING.
33/20/10mm² depending from the model(thicker if planning for additional amplifier) wire
is recommended for both the power and ground wires. 12 Gauge, for the remote turn-on
wire. Both types are available at most Mobile Audio Dealers or Installation Shops.
(1) GROUND: To Vehicle Chassis
To avoid unwanted ignition noise caused by ground loops, it is essential that the amplifier
be grounded to a clean, bare, metal surface of the vehicle's chassis
NOTE:
GROUND WIRE SHOULD NOT BE EXTENDED MORE THAN 3FT(1 METER)
(2) +12 Volt(Fuse) Constant Power: To Battery(+)
Due to the power requirements of the Amplifier, this connection should be made directly
to the positive(+) terminal of battery. For safety measures, install an in-line Fuse Holder
(not included) as close to the battery positive (+) terminal as possible with an ampere
rating; not to exceed total value of fuses in Amp.
(3) Remote Turn-On Input: To Power Antenna output of Car Stereo This Amplifier is turned
"ON" remotely when the vehicle's stereo is turned "ON".
NOTE:
If your radio does not have a +12 Volt output lead when the radio is turned ON,
the "RMT" terminal on the Amplifier can be connected to vehicle's accessory
circuit that is live when the key is "ON".
- 7 -