Danelectro FAB Distortion D-1 Instrukcje - Strona 2

Przeglądaj online lub pobierz pdf Instrukcje dla Pedał muzyczny Danelectro FAB Distortion D-1. Danelectro FAB Distortion D-1 2 stron.

D-1 Instructions

TO BEGIN:

• Connect instrument cable to the IN jack.

Connect amplifier cable to the OUT Jack. If using

an AC Adapter, connect to DC-9V jack. Or use

9Volt battery.

• LED light will be on when foot switch is

activated.

CONTROL FUNCTIONS:

LEVEL: This control sets the level of the output to

the amplifier.

TONE: Rotate this control to adjust the EQ.

DISTORTION: Use this control to set the amount of

Distortion.

caution:

This is a high gain device. Start with the LEVEL

control at 25% and then advance as needed.

FAB

Distortion

DISTORTION:

Adjusts the amount

Adjusts the EQ

of Distortion

INPUT

BATTERY: Uses one S-006P 9-Volt Battery. Danelectro "Vintage Power

Source" batteries are recommended.

BATTERY ELIMINATOR: Uses 9-Volt Battery Eliminator.

Polarity: Center Negative (-). 300mA maximum. Danelectro "Zero Hum"

Battery Eliminators are recommended.

TONE:

LEVEL:

Adjusts the

output level

9V DC

OUTPUT