3S SL-R60S Instrukcja obsługi i konserwacji - Strona 11

Przeglądaj online lub pobierz pdf Instrukcja obsługi i konserwacji dla Sprzęt bezpieczeństwa 3S SL-R60S. 3S SL-R60S 12 stron.

Drukuj stronę

Storage

7.1 Personal protective equipment should be

stored in a cool, dry, clean environment,

and out of direct sunlight.

7.2 Do not expose the fall arrester and full

body harness to the corrosive substances

including oil, grease, paint or other

chemicals. Otherwise the service life of

the product might be shortened.

Repair and maintenance

8.1 When the guide rails and the fall arrester

are found to be contaminated by

corrosive substances such as oil, grease,

paint or other substances during the

inspection following clause,8, please

clean them with warm water and a little

soft detergent. Do not use other cleaning

agents.

8.2 Wipe it off with a clean cloth and then

dry them in air. Do not dry with an

7.3 The reconstruction or modification of

fall arrester is not allowed. 3S Lift will not

assume any responsibility of any injury

or death caused by reconstruction or

modification of the fall arrester.

7.4 The fall arrester and full body harness

should be stored and carried in tool kit or

packing box.

artificial heat source.

8.3 If necessary, a small amount of oil can be

added at the contacts between the rollers

and the shafts, to ensure that the rollers

smoothly rotate without abnormal noise.

8.4 Repair and maintenance must be carried

out by a qualified person who must be

familiar with and fully understand the

instructions.

Appendix

Routine Inspection

Inspection record

Date of inspection:

Inspected by:

Date of initial use:

Inspection items

1. Check and ensure no damage, oil, dust, or dirt on the surface of the fall

arrester.

2. Check and ensure no deformation or fracture of the carabiner. Check

and ensure that the gate of the carabiner can be closed and locked

automatically.

3. Check and ensure all rollers rotate flexibly.

4. Check and ensure no deformation and damage on the fall arrester, and

that the locking lever and swing lever rotate flexibly without clamping

stagnation when the carabiner is lifted, and return to original position

automatically after the carabiner is released.

5. Check and ensure that the push button and rotary knob return to their

original positions after they are released.

6. Check and ensure the shock absorber is intact without being extended.

7. Check and ensure all fasteners are firmly riveted and no obvious tear or

deformation.

This table can only be filled in by competent person, and can be duplicated for further use.

Model/Standard:

Serial number:

Remarks

Yes