Dumor EASYCARD SRA3+ Podręcznik użytkownika - Strona 3

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Laminator Dumor EASYCARD SRA3+. Dumor EASYCARD SRA3+ 8 stron.

Drukuj stronę

Re- lock the knobs

(12)

when the adjustment is complete

2- Next step

Centre the paper in the tray

There are 2 side guides.

The left side guide has a pressure plate with spring preload and adjustment knob.

There is a cut out in the tray in the form of an arrow head

The centre of the sheet must be defined and placed in front of the tip of the arrow head and then the side guides pushed in to lightly

guide the paper.

The spring guide pressure can be adjusted

3- Next step

Check that there is no waste paper in the cutting area.

Lift the top cover and visually inspect the paper flow area, remove waste.

If scrap is in the paper path a jam will occur.

The cassette

(16)

is held to the machine with several knurled knobs (17), remove these to remove the cassette if there is paper

jammed inside.

4- Next step

Correctly position the outfeed tray and extend it as needed

Note: that very long cards will not fit in the tray.

5- Next step

Pre set a job

Turn ON the machine, switch ON

The machine will display some basic information:

- Cut width (determined by the cassette in use either 85 mm or optionally 90 mm)

- Cut length

- Number of cards to be cut

- Sheet size

There are 4 press buttons (Denominated from left to right 1 to 4)

What do they do?

# 1 MODE = cut length selection

Selects the length of cut by increments according to the factory preset values as displayed on the screen.

Press sequentially to scroll through the menu, the value displayed is the value that will be used when you start.

If you overshoot a setting just scroll onwards till the correct value appears again.

The main handbook contains card print templates with the values memorized in the machine.

Note: that if using the standard presets and templates the cut length doesn't fit the printed image on the card (due to print

stretch or shrink) the various cut positions can be over-written by increments of 1/10 mm to compensate the error you do not

need to do a custom program. The limitation of the manual correction is ± 2 mm per line.

#2 PARAMETER

(21)

Selects the adjustment mode

Press sequentially to scroll though the menu.

Depending on mode selected by button nr 2:

#3 + key

(22)

Selects to start the machine / move the sheet forward / increase a value.

(14)

that indicates the centre line.

(13)

using the knob so that the paper doesn't shimmy on infeed.

(15)

(18)

(19)

the infeed side cover under the tray and wait 4 sec for the display to light up.

(20)

(13)

for longer cards to 110 mm