CashConcepts CCE 2000 Podręcznik - Strona 11

Przeglądaj online lub pobierz pdf Podręcznik dla Liczarka banknotów CashConcepts CCE 2000. CashConcepts CCE 2000 14 stron.

CCE – Cash Concepts Europe GmbH

Kemptener Straße 99 – D-88131 Lindau / Germany

Tel.: +49 (0)8382 – 943 15 – 0 / Fax: +49 (0)8382 – 943 15 – 20

Email: [email protected] / Web: www.cce.gmbh

Setting and function

 Add function

The machine disposes of an addition function with add the counting results of several banknote piles one after the other. By

pressure of the key "ADD" you switch on this function or out. In the display the activated function is indicated at the display

by ADD.

 Batch / Counting stop

With the banknote counter you have the possibilities to set up your own counting stop between 1 and 100 by using the keys

"Batch", "+" and "-". If the opposed batch value is reached, the machine stops the counting process. If the counted

banknotes are taken out from the stacker, the machine counts the remained marks further to this have completely run

through or the batch value once more is reached.

By pressing the "BAT" button the preset counting stops (100-50-20-10-off) are retrieved. Use the "+" and "-" buttons to

adjust the values.

 Automatic / manual Start

You can choose between an automatic and a manual start of the counting. Hold the red Start button for about 3 seconds

until "MNL" (manual start) or "AUT" (automatic start) is shown in the display. Press the "+" and "-" buttons to witch between

the versions back and forth. Confirm the desired start function by pressing the red start button.

 Setting the counterfeit detection (depending on the device model)

UV detection:

At the devices CCE 2020 and CCE 2040 you can activate and deactivate the UV detection based on UV features by pressing

the "UV" button. The active status is displayed by UV on the display.

 MG/MT detection:

At the CCE 2040 you can activate and deactivate the MG/MT detection based on MT/MG features by pressing the "MG"

button. The active status is displayed by MG on the display.

Mechanical settings

By the transport and by wear of the transport roles in the upper area a post adjustment of the feeder can be necessary. At the

rear side of the machine is a set wheel which can be easily pressed a little down and changes then by tricks the pressure on the

banknotes.

If the device draws not only one but also several banknotes, turn the set wheel in the direction of "-" sign.

If the device does not draw in the banknotes, turn the set wheel in the direction of "+" sign.