Dune 4WD OUTBACK XL SWAG Instrukcja obsługi - Strona 6

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Namiot Dune 4WD OUTBACK XL SWAG. Dune 4WD OUTBACK XL SWAG 8 stron.

ASSEMBLY INSTRUCTIONS

IMPORTANT: This swag is to be pitched once before going camping to ensure that all parts

are present and to become familiar with the assembly of the swag.

1. Undo straps from clamp‐rings and unroll swag.

2. Unzip the top panel at the head end of the swag and locate the pole pocket containing

the poles at the head‐end of the mattress. Head pole is the longest pole, mid pole is

the next longest and the foot pole is the shortest.

3. a) Join the head pole and slide them through the centre sleeve at the large end of the

swag.

b) Place pole‐ends in the ring and pins in both corners of the swag.

c) Attach "J" hook clips onto head pole.

4. a) Join the foot poles and slide them through the sleeve at the small end of the swag.

b) Place pole‐ends in the ring and pins in both corners of the swag.

c) Attach "J" hook clips onto foot pole.

5. Undo top canvas and mesh panel to below mid‐way down the swag.

6. a) Assemble and inset mid pole in the canvas sockets located mid‐way along the base‐

seams on either side of the mattress.

b) Undo touch‐tape webbing located mid‐way down the canvas centre strip of the

mesh panel. Wrap this webbing around the high‐point of the hooped pole and

reattach the touch‐tape.

7. a) Attach guy ropes to the head‐end storm flap eyelet. Attach to tree/bumper

bar/peg.

b) O‐rings on each corner are for pegging out if necessary.

c) Attach a guy rope to the foot storm flap and attach to a tree/peg. Incidentally, the

O‐rings on the head end of the top panel allow for the panel to be tied up to a

tree/bumper bar. Obviously this is a dry weather option.

When a, b, and c are complete the swag should be taut and not sagging.

8. The touch‐tape webbing loop located on the head end of the centre canvas strip

allows you to keep the mesh panel firm above your face.

How to make the most of your swag if expecting bad weather.

Although no structure is 100% waterproof, by following these instructions you can maximise

your swags performance.

Once step 8 has been completed, totally zip close the mesh and canvas top making sure you

attach the touch‐tape at the centre O‐ring. Then attach the touch‐tape on the weather flap, to

provide a good seal.

Before entering, make sure the swag is firmly pitched so water cannot pool on any surface. All

water is to run off, not lie in creases or folds. Then enter through the head end and reattach

the guy rope if need be. Note that the canvas outer flap at the head end entrance can be

rolled down and tied off with the loops and toggles provided.

Storage

Always store unrolled to keep mattress lofting and canvas aired.

PLEASE NOTE: In severe conditions the swag should be dismantled.