How to navigate?
What do the symbols mean?
The desired flow temperature is influenced by for example return temperature.
The actuator closes the control valve.
The actuator opens the control valve.
The actuator does not activate the valve.
The pump is ON.
The pump is OFF.
The controller is in setback mode.
The controller is in pre-setback mode (the symbol is blinking).
The controller is in comfort mode.
The controller is in pre-comfort mode (the symbol is blinking).
Safety Note
To avoid injury of persons and damages to the device, it is absolutely necessary to read and
observe these instructions carefully. The warning sign is used to emphasize special conditions
that should be taken into consideration.
This symbol indicates that this particular piece of information should be read with
special attention.
VI.KT.F2.02
Adjust temperatures and values.
Switch between menu lines.
Select / return.
2 sec.
Return to daily user menu.
© Danfoss 06/2008
DH-SMT/DK
Table of Contents
Introduction . ................................................................................................. 6
Settings overview
Daily use . ....................................................................................................... 8
Temperatures
Select control mode
Set your personal schedule
Maintenance ............................................................................................... 11
Date - time
Flow temp. (flow temperature control)
Temp. min. (flow temp. limit, min.)
Temp. max. (flow temp. limit, max.)
Return T limit (return temp. limitation)
Limit (return temp. limitation)
Gain - max. (return temp. limitation - max. influence)
Gain - min. (return temp. limitation - min. influence)
Intgr. time (time constant for return temp. limitation)
Control param. (control parameters)
Auto tuning
Motor prot. (motor protection)
Xp (proportional band)
Tn (integration time constant)
M1 run (running time of the motorized control valve)
Nz (neutral zone)
Application
P1 exercise (pump exercise)
M1 exercise (valve exercise)
P1 frost T (frost protection)
P1 heat T (heat demand)
Standby T (standby temperature)
Ext. (external override)
Min. on time (min. activation time gear motor)
Daylight (daylight saving time changeover)
ECL address (master / slave address)
Type
Service
Code no.
Ver. (version no.)
Backlight (display brightness)
Contrast (display contrast)
Language
MOD address (MODBUS address)
VI.KT.F2.02
DH-SMT/DK
Line
Page
1000
2000
2177
2178
4000
4030
4035
4036
4037
6000
6173
6174
6184
6185
6186
6187
7000
7022
7023
7077
7078
7093
7141
7189
7198
7199
7600
8000
8300
8301
8310
8311
8315
8320
© Danfoss 06/2008
7
8
9
9
11
11
11
11
12
12
13
14
14
15
15
16
16
16
16
17
18
18
18
18
18
19
19
19
20
20
21
22
22
22
22
22
23
23
Drukuj stronę