Danfoss ECL Comfort 310 Instrukcja obsługi - Strona 6

ECL Comfort 210 / 296 / 310, Floor (Screed) Drying Program

When the floor drying process is finished, a data log can be read

from the ECL Comfort controller by means of the "ECL Tool". The

data log can be used for documenting the process.

The favorite display with temperature information of the heating

circuit(s) can, as an example, look like this:

Floor drying process not active:

Floor drying process active:

The progress bar is filled up from left side, according to time

elapsed since process start. The elapsed time and total process

time is also indicated in hours.

Return temperature related indications are not present, as the

return temperature limitation is cancelled during the floor drying

process.

Floor drying process being active can also be seen:

Circuit x > MENU > Influence overview > Des. flow T:

Before start of the floor drying process:

•

The control parameters must be set correctly (Circuit x > MENU

> Settings > Control parameters). See the Operating Guide for

the application in question.

•

The Time & Date must be set correctly (Common controller

> MENU > Time & Date). See the Operating Guide for the

application in question. The Time & Date settings are used in

the log facilities.

The mode selector of the ECL Comfort controller must not be in

Manual mode when the floor drying process is in progress.

VI.JM.P2.02