Danfoss FH-CWP Instrukcja obsługi - Strona 12

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Termostat Danfoss FH-CWP. Danfoss FH-CWP 20 stron.

Instruction FH-CWP Thermostat

9. Frost protection

Using the Frost Protection Mode instead of turning the

thermostat OFF completely may protect against dam-

ages due to low temperatures. The room temperature

will be maintained around 5 °C.

Turn OFF the thermostat by pressing

Fig. 1.

• Press M Fig.1 for 3 seconds and release.

• Select 01 (00= disabled).

If the temperature is lower than 5 °C the heating will

be turned ON and

will be shown in the display.

If the temperature is higher than 7 °C the heating is

turned OFF.

Factory setting is 00.

E1 will be displayed when room sensor failure.

E2 will be displayed when floor sensor failure.

E2 will be read when pressing M Fig. 1 to check

floor temperature.

Any case, all relay output would be turned off.

VI.CU.C2.02

Produced by Danfoss Floor Heating Hydronics 05.2011