Danfoss HP8211-1RJ Instrukcja instalacji - Strona 6
Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Termostat Danfoss HP8211-1RJ. Danfoss HP8211-1RJ 8 stron. Heat pump thermostats
Drukuj stronęDETAILED DESCRIPTION OF ADVANCED PROGRAMMING MODE (APM) OPTIONS
To enter Advanced Programming Mode (APM) press and hold FAN and COPY buttons for 3 seconds. Note: the thermostat must be in
nomal running mode (not programming mode).
When in APM mode use the ▲ and ▼ buttons to scroll through the options available. Use the Next button to move onto the subsequent
option.
Option 1
Setting temperature override duration timer
(not available if "Non-Prog" is selected on DIP switches 1 & 2)
This feature allows the building owner to determine the duration of any temporary temperature override selected by the
user.
Option 2
Setting fan run-on after cooling demand
This feature allows the installer to select a timed fan run-on following each cooling demand.
Option 3
Setting fan run-on after heating demand
This feature allows the installer to select a timed fan overrun following each heating demand.
Option 4
Enabling or disabling programmable occupancy programming
(not available if "Non-Prog" is selected on DIP switches 1 & 2)
This feature allows the operation of the fan to be programmed to Auto or On, and the occupancy relay contacts to be
opened or closed, during each event. Setting these options is affected during the event programming process. See step
3 para 3.1 through to 3.5 on page 4.
Option 5
Setting fan operation mode
(not available if "Non-Prog" is selected on DIP switches 1 & 2)
This feature allows the building owner to determine what mode the fan will operate in and what overrides will be available
to the user.
Option 6
Selecting extent of keyboard disable function. active only when dip switch 5 is set to "keyboard disable"
This feature allows installer to determine the extent of the disablement of keyboard functions if DIP switch 5 is set to
"Keyboard disable". See table below:
Feature
Access to programming mode
Access to advanced programming mode
Access to service mode
Access to Hold & Vacation mode
Access to Daylight Savings Time Change
Selection of AM/PM or 24 hour clock
Selection of Fahrenheit or Centrigrade scaling
Mode select (auto/heat/cool/off)
Mode select (EM heat, Heat-pump models)
Fan Mode (Auto/On/Smart-fan)
Temperature override (including duration)
View temperature information
Change display time to temperature
Note :
Settings of options 7 through b are dependent on each other. Not all settings will be accepted and an ERR message
may be experienced. If this occurs press (▲) or (▼) to make the setting valid. Alternatively press NEXT button to return to
option 7 and review the settings.
Option 7
Setting heating / cooling dead-band adjustment (not available if "Changeover Manual" is selected on DIP switch 6)
This feature allows the installer or the building owner to determine minimum dead-band between heating and cooling.
Option 8
Setting maximum heating temperature set point
This feature allows the building owner to determine the maximum heating temperature available to the user.
Option 9
Setting minimum cooling temperature set point
This feature allows the building owner to determine the minimum cooling temperature available to the user.
6
Part (nor)
✘
✘
✘
✘
✓
✓
✓
✓
✓
✓
✓
✓
✓
Full
✘
✘
✘
✘
✓
✘
✘
✘
✘
✘
✘
✓
✓