3T-Components 3T-MOTORS 3T45-20RNH Instrukcja instalacji i obsługi - Strona 8
Przeglądaj online lub pobierz pdf Instrukcja instalacji i obsługi dla Wyposażenie wnętrz 3T-Components 3T-MOTORS 3T45-20RNH. 3T-Components 3T-MOTORS 3T45-20RNH 20 stron. Radio shutter / awning motors
Drukuj stronę
MONTAGEANLEITUNG
Remove shutter shaft:
2
Lower the roller shutter.
•
Open the cover of the roller shutter box.
•
Release the suspension springs from the roller shutter shaft.
•
Lift roller shutter shaft incl. ball bearing out of the holder.
•
Prepare motor for installation:
3
Push limit switch adapter flush against motor head.
•
Secure the shaft adapter with the supplied securing bracket.
•
Push the motor into the roller shutter shaft without using force (never knock it in). The fold of the shaft must lie over the recess in the shaft adapter.
•
Make sure that the roller shutter shaft is flush with the motor head limit switch adapter.
•
3.1
Motor head
Limit switch adapter
3.5
Roller shutter shaft
Mount bearings:
4
Remove old wall bearing on motor side (left or right installation possible).
•
Mount motor bearing at this point (2 mounting options: Universal bearing & cotter pin and cover cap bearing & securing clips / clip bearing).
•
Please mount the bearings so that the limit switches are freely accessible.
•
Make sure that the roller shutter motor with the shaft unit sits horizontally in the roller shutter box.
•
Mount motor with shaft unit:
5
Insert the motor head (with the entire shaft unit) into the motor bearing and secure it with the supplied cotter pin or securing clips (Cover cap bearing).
•
>
fig. 3.1 / 3.2
>
fig. 3.3 / 3.4
3.2
Fold
3.6
Recess
>
fig. 3.7 / 3.8
3.3
Securing bracket
3.7
wrong
3T-MOTORS Radio tubular motors | Installation instructions
>
fig. 3.5 / 3.6
Shaft adapter
3.4
Click
3.8
right
8