Danfoss APP 38/1 Instrukcja serwisowa - Strona 8

Przeglądaj online lub pobierz pdf Instrukcja serwisowa dla Pompa wodna Danfoss APP 38/1. Danfoss APP 38/1 20 stron. Disassembling and assembling

Disassembling and Assembling, APP 21-43

Service guide |

8 | 180R9121 | 521B1018 | DKCFN.PI.013.A6.02

16. Retainer guide, retainer ball and

retainer plate must be mounted as

indicated in below picture.

18. Place retainer plate in cylinder barrel.

Note: If pistons are replaced, place new

pistons in clean filtered water for a

couple of minutes. Exercise piston shoes

to make them "run" smoother.

21. Remember to place the guide pin in the

housing.

22. Place three bolts in mounting flange.

Turn each bolt one round at a time to

ensure mounting flange is mounted as

straight downwards as possible. Be careful

not to squeeze O-ring.

17. Ensure that retainer plate is oriented

correctly, i.e. with its slant surfaces

pointing downwards.

19. Place pistons in retainer plate and

cylinder barrel.

When pistons are placed, tilt retainer

plate for easier placement of swash plate.

If swash plate has been disassembled from

mounting flange, see page 10 for assembly

of swash plate.

20. Lubricate piston shoes and swash plate

with clean filtered water. Remember to

place the pins in housing.

Note: Screws for lifting eye are

shorter than the rest.

23. Screw in the rest of the bolts and cross

tighten all screws to a torque according to

exploded view.