Danfoss APPW 5.1 Instrukcja serwisowa - Strona 2
Przeglądaj online lub pobierz pdf Instrukcja serwisowa dla Pompa wodna Danfoss APPW 5.1. Danfoss APPW 5.1 12 stron. Disassembling and assembling
Drukuj stronę
Disassembling and Assembling, APP(W) 5.1-10.2
Service guide |
Table of Contents
Introduction
2 | 180R9238 | DKCFN.PI.078.F3.02 | 521B1196
Contents
Introduction ................................................................................................................................................................................2
1.
Disassembling the pump ..............................................................................................................................................3
2.
Assembling the pump ...................................................................................................................................................5
3.
Disassembling swash plate ..........................................................................................................................................6
4.
Assembling swash plate ................................................................................................................................................7
5.
Change of shaft seal .......................................................................................................................................................8
6.
Exploded view for APP (W) 5.1-10.2 ...................................................................................................................... 12
NOTE: If the pump is disassembled within the warranty period, the pump is no longer covered
by the warranty.
This document covers the instructions for
disassembling and assembling the axial piston
pump APP(W) 5.1-10.2
Important: It is essential that the pump is
serviced in conditions of absolute cleanliness.
To understand the pump design better, please
see exploded view on last page.
Tools needed:
• Toolset (code no. 180B4162)
• Seal set (code no. 180B4161)
• Screwdriver
WARNING: Do not reuse disassembled O-ring
or shaft seal as they might be damaged.
© Danfoss | DCS (im) | 2017.06