Dunlop L.MAS.MOV.C.M Instrukcja instalacji - Strona 9

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Akcesoria samochodowe Dunlop L.MAS.MOV.C.M. Dunlop L.MAS.MOV.C.M 20 stron. Auxiliary air suspension

Drukuj stronę

Nissan Interstar

iii.

After connecting it to each other again on the mall bracket. It is

needed to bleed the brake line at the left side.

5.4 Fitting of Lower Bracket

Rest the lower bracket on the axle directly below the upper plate,

with the two 'feet' placed beneath the leaf spring mounting block—

Figure 6

ii.

Insert the two M10 x 100mm countersunk bolts into the countersunk

holes in the lower bracket, feed the lower bracket strap up from

below the axle to mate with these bolts, and install the nuts and

washers to secure the lower bracket and strap against the axle—

Figures 6 and 7

5.5 Bellow Installation

See Section 5.6 - "Tube Connection and Disconnection, Cutting and

Routing" : Connect a tube to the bellow by pushing the tube into the

air inlet port on the underside of the spring and then hand-rotating

the tube by one screw turn.

bellow and blue for the right-hand bellow. Feed the tube through

the large exposed hole in the upper bracket—Figure 8.

ii.

Place the bellow into position between the upper and lower brackets

and attach the lower plate of the bellow to the lower bracket using

two M8 x 16mm bolts and two washers—Figures 8 and 9

iii.

Attach the top plate to the top plate of the bellow using a single M8

x 20mm bolt and a single M8 serrated washer—Figures 10 and 11

DUNLOP and the Flying D Device are trademarks of Dunlop International Group and are used under license by DSC Nederland B.V.

Opel Movano

L.MAS.MOV.C.M

Use black tubing for the left-hand

Renault Mastervan