DUO-FAST DF175-CN Instrukcja obsługi i schemat - Strona 6
Przeglądaj online lub pobierz pdf Instrukcja obsługi i schemat dla Pistolet do gwoździ DUO-FAST DF175-CN. DUO-FAST DF175-CN 12 stron. Cap nailer
Drukuj stronęLOADING THE NAIL COIL:
1.
2.
LOADING THE PLASTIC COIL:
3.
4.
LOADING AND OPERATION
Disconnect the tool from air supply.
before loading a new nail coil.
Pull down door latch and open the door. Swing magazine cover open.
The tool must be set for the length of nail to be used. Nails will not
feed smoothly if the magazine is not correctly adjusted. The magazine
contains adjustable nail platform on which the nail coil rest. The nail
platform can be moved up and down to three settings. To change
setting pull on the post and twist to the correct step. (See Picture 1)
damage the nail feed mechanism.
Place the coil of nails over the post in the magazine. Uncoil enough
nails to reach the feed pawl. Place the first nail in front of the front
tooth on the feed pawl in the driver channel. The nail heads must be in
the slot in the nose. (See Picture 2)
Swing the latch door and magazine cover closed. Check that the latch
pin engages when released and that the magazine cover is behind the
latch.
Disconnect the tool from air supply.
Pull open cap canister lever and remove empty paper spool. Remove
the tape from the end of the cap strap on the spool. Push the spool over
the canister spindle and feed the caps into the track. (See Picture 3)
Advance the caps to the front of the track by pushing the caps from the
open bottom of the track. Close the cap canister lever and push until
the lever snaps onto the rim of the canister. (See Picture 4)
(4)
WARNING
Check to make sure there is no nail in the outlet site
Failure to adjust magazine height for nail size may
WARNING