Duolabs Qbox One Skrócona instrukcja obsługi - Strona 6

Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Odbiornik Duolabs Qbox One. Duolabs Qbox One 15 stron. Dvb-s sat receiver

Explanation Front Panel

Double Smartcard Reader

Insert your Smartcard with the golden chip facing down and forward into the Smartcard reader.

Standby LED

The Standby LED lights up red if the QBox is in standby mode. It lights up green if the QBox is powered on.

Remote Control (RC) Led

The remote control LED lights up every time the QBox receives a signal from the remote control.

Standby on/off

USB Port

The USB port will handle the PVR and other functions. In this port you can insert only USB compatible devices such

as PEN sticks or USB Hard Disks.

Explanation Rear Panel

Video output (FBAS)

You can optionally connect your QBox to a TV using a RCA/Chinch cable. (Composite)

Audio output - analog (Cinch)

Connect your QBox with a RCA/Cinch cable to your HiFi-Amplifier (e.g. AUX In or Tape In ports).

Serial interface (RS232C, Sub-D, 9-pin)

The Serial Port is used to update the operating system. Please connect a serial null modem cable here.

TV Scart

Connect your TV or beamer to your QBox using a Scart cable.

Audio output SPDIF - digital (Toslink)

You can connect your Qbox with an optical (Toslink) cable to your HiFi-Amplifier or DSP. The AC3 signal is also

available at this port in case the selected channel transmits Dolby Digital signals.

Power supply connector

Plug the power cable of the power supply that came with your QBox into power outlet. Connect your power supply

to your Qbox. You must not connect the power plug of the power supply to anything other than a socket that

supplies 230V/50Hz.

Network interface (Ethernet 10/100Mbit, RJ45)

The Communication Port is an Ethernet port. It is used to communicate with your QBox via HTTP, FTP, NFS,

Telnet and Samba. This port is also used to update the operating system of your QBox. Please use a regular patch

cable to connect your QBox to your LAN.

The factory set username and password to get access to the QBox are:

Username: root

Password: qboxqbox

USB Port

The USB port will handle the PVR and other functions. In this port you can insert only USB compatible devices such

as PEN sticks or USB Hard Disks.