Audiocom Audiocom BP-2002 Instrukcja obsługi - Strona 10

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla System interkomu Audiocom Audiocom BP-2002. Audiocom Audiocom BP-2002 18 stron. Beltpacks audicom intercom systems

Drukuj stronę

Changing Modes of Operation

Perform the following steps to change the mode of operation.

NOTE:

Both the Talk and Call indicators should be OFF and the headset should

be connected.

Press and hold the Talk key, and then press and hold the Call key.

Release both keys.

10.

The Call indicator should now glow red. (The number of beeps heard in the

headset indicates the current mode of operation.)

Press the Call key to change to the next mode of operation.

11.

Each press of the Call key will cause the BP-1002/2002 to change to the next

mode of operation.

When the desired mode is reached, press the Talk key to select that mode

12.

and exit the mode changing function.

Beeps will be heard in the headset when the mode changing function is

exited. The number of beeps hears indicates the selected mode of operation.

NOTE:

Modes of Operation

TABLE 1.

Mode (beeps)

2 (default)

Internal Switches, Jumpers and Adjustments

There are several internal switches, jumpers, and adjustments that affect operation.

These are described below. To gain access to the switches, jumpers and adjustments,

disconnect all power and line connections. Remove two screws from the top of each

side and two screws from the bottom of each side. Switch, jumper and adjustment

locations are shown in Figure 2.

Operation

Each time the intercom system power is turned ON, the

beltpack will reset to the default mode of operation (mode

2).

Mic Kill

Disabled

Enabled

Disabled

Enabled

Audible Call Alert

Disabled

Enabled