Duplex STEAMTECH 4000 Podręcznik użytkownika - Strona 13

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Odkurzacz parowy Duplex STEAMTECH 4000. Duplex STEAMTECH 4000 20 stron.

STEAMTECH

OPERATING THE STEAMTECH WITH KIT RADAMES / STAR

Insert the vacuum hose (30) into the vacuum hose outlet (6) and the steam plug (32) into the steam outlet (22) on the machine.

In case your machine is a 6 bar model (see the technical data located under the machine), it is necessary to insert also the hook to fix the

hose (39). Push until the latches (5 and 31) lock into place.

Activate the general power switch (11) and switch it to the position "boiler ignition" (13) for the production of steam and wait approx. 3-8

minutes (depending on the model) until the green "ready steam" indicator (14) lights up indicating the boiler has reached its operating

pressure. The switches (36,37 and 38) located on the handle have to be in the OFF position.

Positioning the switches (36 and 37) on the handgrip will regulate the steam flow as follows: switch (36) minimum flow, switch (37) medium

flow, switches (36 and 37) maximum flow. Use the steam command switch (34) to activate steam flow.

The vacuum switch (38) activates the vacuum cleaner and can be used simultaneously with steam.

The detergent switch (35) or (35A, for models with hot water injection) enables you to inject detergent with the steam by activating it for a few

seconds at a time to avoid excess liquid with the steam; to spray hot water please refer to what previously indicated activating the switch

(35B).

Attention!!

Using the switch (35B) you will get hot water under pressure which, according to the model of the machine,

can reach a temperature of 180°c; please pay attention that the switch has not to be pressed accidentally

and that the jet has not to be directed toward people or animals.

To clean with the combination of steam, injection of detergent and vacuum suction, choose the accessory best suited for the job:

The multi-purpose floor tool (51): with appropriate inserts (53,54,66). Inserts are locked into place by sliding the latches (52) toward the

internal side (OPEN position), pressing them upwards, then sliding the latches toward the external side (BLOCK position). By consequence

apply the tool on the hose or on the extension tubes and lock them by sliding the latches (40) in BLOCK position, then screw the handle

screw (40A) (only for 10bar models). Remember that the command switches on the handle (36-37-38) must be on OFF position until the end

of this procedure.

Turbo lance steam/vac (42): to be used by itself with the small round brushes (43-46, 49) or with steam plunger (47) and steam scraper

(48) according to the cleaning job to be executed. To fix this tool please refer to the fixing instruction indicated above.

Once the cleaning is finished it is recommended to vacuum approx. 3-5 litres of clean water to rinse the inside of the hose (33) and the

suction conduits. Wash and dry all accessories used. Remove the vacuum drum (4) and, after emptying and rinsing it, let it dry before storing

it away.

DUPLEX UK– 01/17