AudioControl LC7i PRO Skrócona instrukcja obsługi - Strona 3

Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Sprzęt komputerowy AudioControl LC7i PRO. AudioControl LC7i PRO 13 stron.

Quick Start

Since some of you over-caffeinated enthusiasts will want to install your LC7i
PRO on your own, here are a few general steps to get you up and running.
You should also refer to the additional sections of this manual for more
information and installation examples.
1. LC7i PRO is active and REQUIRES CONSTANT +12V POWER
2. Pick a suitable mounting location that will provide access to the controls
and connections. Protect the LC7i PRO from heat, moisture, and dirt.
3. Use the integrated mounting brackets to mount the LC7i PRO.
4. Before drilling holes, take every precaution to prevent damage to fuel
lines, power and other electrical wiring, hydraulic brake lines, and other
systems that might compromise vehicle safety.
5. When making connections, designate red RCA plugs as right, and
designate white, black, or gray plugs as left.
6. Connect the +12V input terminal of the unit to the +12V terminal on the
vehicle battery (or distribution block) using 16 to 14 AWG.
7. Connect the Ground terminal of the unit to the Ground/Negative
terminal of the battery (or distribution block) using the same gauge wire
as the +12V power wire.
8. For +12V remote turn on the Trigger Mode switch must be set to "Rmt In".
Connect the Remote In (Rmt In) terminal of the unit to a remote turn-on
switch. Alternately, use GTO™ Signal Sense or Audio Sense to trigger the
unit on without a remote wire.
9. Connect the speaker outputs of your factory head unit or amplifier to the
Speaker Level Inputs on the LC7i PRO.
10. Run the ACR-1 remote wire to the front of your vehicle.
11. Connect the Channel Output RCAs to your aftermarket amplifier.
12. Connect the Remote Out (Rmt Out) to your aftermarket amplifier.
13. Adjust the input gain using the Output Level knobs.
14. Adjust AccuBASS using the AccuBASS Threshold and Level knobs.
15. Enjoy the drive!
3