FREEDOM GRILL FG-50 Instrukcja obsługi - Strona 9

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla grill FREEDOM GRILL FG-50. FREEDOM GRILL FG-50 12 stron.

Drukuj stronę

Air Mixture Adjustment :

The air mixer sleeve for the burner has been pre-set at the

factory for gas conditions at sea level. However, if the burner

fl ame is too yellow (this may occur at higher altitudes) open

the air mix sleeve slightly until the fl ame turns blue.

G E N E R A L M A I N T E N A N C E

Main Burner Cleaning Procedure :

Turn off the gas supply. Remove the burner. (See below)

Look inside the burner with a fl ashlight. Clean the inside of

the burner with a wire. (A straightened-out coat hanger will

work)

Check and clean the opening at the end of the burner. Check

and clean the valve orifi ce at the base of the valve. Use a

Steel bristle brush to clean outside of burner. This is to make

sure all the burner ports are fully open.

CAUTION: Do not enlarge the burner ports when

cleaning.

Removing Burner Tube :

Your FG-50 grill must be OFF and cool.

Unscrew and remove propane cylinder from the valve/

regulator assembly.

Open the lid.

Remove cooking grate.

Remove the drip vaporizer.

Unscrew and remove the (3) 1/4" screws that hold the

burner tube inside grill basin.

Carefully slide the burner tube out from the grill basin.

To reinstall the burner, reverse the above steps. Check

proper assembly before fastening burner tube in place.

CAUTION: The burner opening must be positioned

properly over the valve orifi ce.

Ignition System Operations :

This appliance has an electronic igniter that uses a triple A

battery (AAA – V.), (battery should be checked periodically).

The grill can also be lit using a match clip extender, via the

fl ame view window. Follow the lighting instructions exactly

when lighting the grill.

Battery Check:

The battery compartment is located behind

the electronic igniter push button on the

control panel. Rotate the push button

counter-clockwise to expose the

battery compartment. When

replacing the battery be

sure to attach positive

and negative ends

correctly. Check the

igniter by pressing the

button. You should hear

a "clicking spark" sound.

S T O R A G E A N D / O R N O N U S E

When the FG-50 is not in use or is being transported, the

propane cylinder must be DISCONNECTED and the

propane cylinder stored in a well-ventilated space.

DO NOT DRIVE WITH THE CYLINDER ATTACHED!

The FG-50 should be checked for gas leaks and any

obstructions in the burner tubes before using. (See Sections:

"General Maintenance and Annual Maintenance.") The

burner tube should also be checked for any obstructions.

(See Section: "Annual Maintenance.")

L I C E N S E P L AT E B R A C K E T

If the Freedom Grill blocks the visibility of your vehicle's license

plate remove the license plate and mount it on the temporary

license plate bracket on the upper swing arm as shown. Be sure

to replace the license plate when you remove the Freedom Grill

from your vehicle.