Conquer 330-TMDSK01 Instrukcja obsługi i montażu - Strona 14

Przeglądaj online lub pobierz pdf Instrukcja obsługi i montażu dla Sprzęt fitness Conquer 330-TMDSK01. Conquer 330-TMDSK01 14 stron.

Drukuj stronę

TROUBLESHOOTING GUIDE

Error
Cause
code
E01
No sensor signal
Over-voltage protection of the
E02
motor
E03
Over-current protection
E04
Open circuit
E06
Message failure
E07
Emergency switch off
EMAIL:
Product name: Conquer Treadmill Desk
SKU: 330-TMDSK01
EMAIL:
TEL: 855-349-4327
help.conquerequipment.com
Checking
1. Check the distance and place
between sensor and magnet.
2. Check if the wire is broken.
3. Check if the magnetism is
good.
4. Check if the controller is
damaged.
1. Check if the network voltage is
stable.
2. Check if the controller is
damaged.
1. The machine is overloaded.
2. Check if the motor or the roller
gets stuck by something.
3. Check roller lubrication.
4. Check if the controller is
damaged.
5. Check if the motor is damaged.
1. Check the wires of the motor
are connected well.
2. Check if the motor is
open-circuit.
3. Check if the controller is
open-circuit.
1. Check if the connecting wires
are plugged well.
2. Check if the connecting wires
are broken.
3. Check if the console is broken.
4. Check if the controller is
damaged.
1. Check if the emergency switch
is attached.
WEB: help.conquerequipment.com
Correction
1. Adjust the distance between
the sensor and the magnet.
2. Change the wire.
3. Change the magnet.
4. Change to a new controller.
1. Regulator is needed to adjust
the voltage.
2. Change to a new controller.
1. Verify user weight is within
allowed parameters
2. Take the foreign matter out.
3. Lubricate the roller.
4. Change to a new controller.
5. Change to a new motor.
1. Connect the motor wires
properly.
2. Change to a new motor.
3. Change to a new controller.
1. Plug all the wires properly.
2. Change to the new wires.
3. Change to a new console.
4. Change to a new controller.
1. Attached the emergency
switch.
TEL: 855-349-4327