Conquer 330-UDTM Podręcznik - Strona 6
Przeglądaj online lub pobierz pdf Podręcznik dla Bieżnia Conquer 330-UDTM. Conquer 330-UDTM 7 stron. Under desk treadmill
Drukuj stronę
3. How to align the treadmill's belt: Over time and repeated use, the belt may move off center
and will need to be realigned. If the belt has moved to the left, start treadmill and increase
the speed to 3/mph. Use 5mm wrench to turn the fixed left bolt clockwise or turn the fixed
right bolt counterclockwise. If belt moves to the right, then adjust the screw on the right side
clockwise or the screw on the left side counterclockwise. Don't tighten the belt too much.
Repeat this procedure until the belt is properly aligned. See fig. 2 and 3.
Fig. 2
Tighten the treadmill's belt (if the belt slips on the treadmill
4.
when walking). Start treadmill and increase the speed to 3/mph.
Using the 5mm Wrench, turn both bolts 1/4 clockwise (Fig. 4, 5). To see
if the belt is properly tight to walk, you should be able to pull up
each side of the belt 5 or 7 cm off the platform.
Be careful and keep the belt aligned. Repeat this procedure
until the belt is properly tightened.
Fig. 5
EMAIL:
Fig. 3
If belt deviates to the left,
如 果 跑 带 左 偏 ,则 顺 时 针 调 节 左
then adjust the screw on
边 螺 丝 或 逆 时 针 调 节 右 边 螺 丝
the left side clockwise or
the screw on the right side
counterclockwise.
If the belt slips, use 6mm
wrench, turn both side bolts
1/4 clock-wise. Repeat this
procedure until the belt is
properly tightened.
WEB: help.conquerequipment.com
Product name: Conquer Under Desk Treadmill
SKU: 330-UDTM
EMAIL:
TEL: 855-349-4327
help.conquerequipment.com
Fig. 4
TEL: 855-349-4327
If belt deviates to the right,
如 果 跑 带 右 偏 ,则 顺 时 针 调 节 右
then adjust the screw on
边 螺 丝 或 逆 时 针 调 节 左 边 螺 丝
the right side clockwise or
the screw on the left side
counterclockwise.