Daniamant Dan W2 Instrukcje instalacji i konserwacji - Strona 3
Przeglądaj online lub pobierz pdf Instrukcje instalacji i konserwacji dla Latarka Daniamant Dan W2. Daniamant Dan W2 4 stron. Lifejacket light
Drukuj stronęMaintenance
Routine service
Dan W2 is maintenance free, but the following checks must be made annually:
1. Inspect the light for signs of damage or corrosion.
2. To test the Water activation – a paper clip may be applied to the 2 water
contacts. It is recommended that the light is activated for 1 minute.
Replacement
The Dan W2 lifejacket lights have a storage life of 5 years and must be replaced
by the date shown on the label.
Health and safety information
Dan W2 lights contain Lithium cells. These must be handled correctly:
Do not dismantle the light assembly
Do not make any external electrical connection
Do not recharge
Do not incinerate
Store between -30°C and +65°C
The Batteries are hermetically sealed pressurised primary Lithium/Manganese
cells, and as supplied are electrically protected by a solid state device, and are
environmentally protected by a moulded plastic housing. In this condition the units
pose no definable hazard to health.
Information on the composition and behaviour of these products is contained in
the Product Safety Data Sheet, available from our website
(www.daniamant.com) or on request.
Disposal
Dispose of used and expired lights in accordance with local regulations. This
could be done through an approved environmental disposal agent.
3