Brakel & Zwaan SSG-101 Podręcznik - Strona 5

Przeglądaj online lub pobierz pdf Podręcznik dla Sprzęt oświetleniowy Brakel & Zwaan SSG-101. Brakel & Zwaan SSG-101 20 stron.

INSERTING / REPLACING BATTERIES

Keep batteries out of reach of children.

Do not leave batteries lying around in the open; there is a risk of them being swallowed by children

or domestic animals. If they are swallowed, consult a doctor immediately.

Leaking or damaged batteries can lead to caustic burning of the skin. Therefore, use suitable

protective gloves.

Batteries must not be short-circuited, opened or thrown into a fire. There is a risk of explosion!

Do not recharge normal, non-rechargeable batteries, risk of explosion! Only recharge rechargeable

batteries that are intended for this purpose; use a suitable battery charger.

Please pay attention to the correct polarity (plus/+ and minus/-) when inserting the battery.

Remove batteries from the device if you will not be using it for a longer period.

●

Open the battery compartment on the bottom of the remote control.

●

Insert a new CR2025 battery in the remote. The correct

polarity is stamped on the bottom of the battery compartment .

●

Push the battery compartment lid back on again.

●

If the remote control does not function anymore, the batteries have to be replaced

PLACING PRODUCT

●

Place the product like in the image

●

Make sure to clean the surface of the

interieur where the leds will be placed

●

When all the wiring has been layed out,

the strips can be placed on the surface

by getting rid of the 3M protection lid.

Tip: Slightly heat the adhesive strip with

a lighter before placing, making it hold

longer. Make sure to only do this when

the led lights are off and not connected to

the power.

●

When the strips are placed, firmly press

onto the surface and hold the pressure

on to the strips for about 15 seconds.

●

You're done! You can organize and conceal the wires by using tape or glue.