DANLERS COPD17M Uwagi dotyczące instalacji - Strona 2

Przeglądaj online lub pobierz pdf Uwagi dotyczące instalacji dla Czujniki bezpieczeństwa DANLERS COPD17M. DANLERS COPD17M 2 stron. Compact person detector, pir switch

Drukuj stronę

Installation procedure

1. Please read these notes carefully before commencing work.

In case of doubt please consult a qualified electrician.

2. Make sure the power is isolated from the circuit.

3. If mounting on a lighting batten, Remove the 20mm thread from the PIR

and insert it through the 20mm knockout hole with the thread facing

outwards.

4. The detector should be connected as shown in diagram D

Brown - Live in. Blue - Neutral in. White - Switched Line out.

5. Feed your cable through the thread and with the PIR facing downwards

tighten the 20mm thread to ensure a tight seal.

6. The detector can be mounted up to 17 metres high.

7. The detector can also be mounted via any of the four pre-drilled

mounting holes (see diagram E).

8. Make sure the power is still isolated from the circuit.

Once the wiring has been completed and verified, switch on the supply

and test the operation.

Time set-up

To set the TIME to a value suitable for the application, turn the PIR time to

the desired timeout (diagram C). Whenever a person is detected, the time

lag will start again and the load will stay switched on.

A: Ceiling mounted

Strong detection zone

detection range

i.e. person moving arm

or walking towards PIR

For optimum coverage

recommended mounting

height 17m

For optimum coverage recommended

Secondary detection

zone i.e. person walking

perpendicular to PIR

up to 20m

up to 24m

mounting height: 17m

B: Wall mounted detection range

C: Time adjustment

D: Wiring diagram

2.5m

80s

optional manual

40s

10m

wall switch for

20s

20m

overriding off

10s

40m

1000 LUX

230 VAC

min

max

TIME

Inside detector

housing

COPD17M can also be wired in parallel

E: Dimensions

front

side

20mm threaded

entry spout

Recommended wall mounting

height 1 to 2.2 metres

Strong detection zone (up to 10m)

COPD17M

10 LUX

load

max

min

LUX

inside

4 x mounting

holes.

3M screws

recommended

(not supplied)