Audionet AMP III Podręcznik użytkownika - Strona 8

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Wzmacniacz Audionet AMP III. Audionet AMP III 16 stron. Three channel power amplifier
Również dla Audionet AMP III: Instrukcja obsługi (11 strony)

Drukuj stronę

Installation and power supply

Important

For connecting or removing loudspeakers and/or the pre ampli-

fier your AMP III must be switched off to prevent damage on the

amplifier or the connected units.

Please make sure that all cables are in absolute best conditions!

Broken shields or short-cut loudspeaker cables could damage

speakers and/or amplifiers.

4.1 Placement

Please find a place for your Audionet AMP III that is sufficiently venti-

lated to allow the heat to dissipate. It is recommended to place the

AMP III into a high quality rack or onto a stable table. Do not expose the

unit to direct sunlight. Do not place the unit in close range to heat sources

like radiators. Do not cover the ventilation slots of the AMP III.

4.2 Mains connection

The mains input 7

is on the back panel of the AMP III. To connect the

unit to mains use the included mains cord. If you want to use a different

power cord make sure that it meets the specifications for your home

country.

Important

The electrical specifications printed onto the back panel must meet

the electrical specifications of your home country.

The AMP III is a Class I unit and must be earthed. Please ensure a

stable earth connection. 'Phase' ('hot' pin) is marked on the back panel

('PHASE') 6 .

Never pull the mains plug while the AMP III is switched on. Always

power down the unit to stand-by mode first, before you use the mains

switch 5 on the back panel or pull the mains plug.

see numbers in section 'Back panel'