Audionet PRE I G2 Instrukcja obsługi - Strona 4

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Wzmacniacz Audionet PRE I G2. Audionet PRE I G2 15 stron. Stereo – pre - amplifier

Outputs

The Audionet PRE 1 G2 has one unbalanced output (5) and one balanced

output for connecting power-amplifiers.

Please connect left and right outputs to the corresponding inputs of your

power amplifier.

Recording systems

Two recording systems can be connected at the same time to PRE 1 G2

for recording and playing back simultaneously.

Rec out

For recording please connect the inputs of your recording system, like

DAT or tape deck with the rec output (6) of your PRE 1 G2. Every time

when the recorder is connected to the rec outputs, please use the inputs

No.5 named "Tape" for playing back.

When input No.5 is selected, the corresponding rec output will be muted.

This is necessary to prevent destructive oscillation of the pre amplifier and

the recorder. Therefore every signal source that should be recorded has to

be connected to the remaining inputs.

Monitor

Your PRE 1 G2 is fitted with a monitor loop. This enables you to listen to

the recorder without interrupting the signal source being recorded. To use

this feature please connect the inputs and outputs of the recorder with the

corresponding monitor output and input (7) of your PRE 1 G2.

Phono

Your PRE 1 G2 can be equipped with an optional phono preamplifier. For

connecting a record player please use the input 6 and the corresponding

ground connector in this case.

Audionet-link

In combination with the Audionet AMP I/AMP II and/or DAC the PRE 1

G2 can switch on and off the whole system. Please connect the Audionet

link (8) on the rear with a Toslink optical fibre cable to the Audionet link

of AMP I and/or DAC.