Danner 03881 Instrukcja montażu i obsługi

Przeglądaj online lub pobierz pdf Instrukcja montażu i obsługi dla Fontanna zewnętrzna Danner 03881. Danner 03881 2 stron.

Drukuj stronę

Santa Fe - Item # 03880

"O" Ring

Fig. B

Fig. A

IMPORTANT:

BEFORE PROCEEDING TO STEPS 4 & 5 MAKE SURE THE CONNECTORS FOR THE PUMP AND L.E.D. LIGHTS HAVE

"O"RINGS INSTALLED ON THEM (SEE FIG. A)

SET THE "FLOW CONTROL" ON THE PUMP TO THE FULLY OPEN POSITION. DO THIS BY SLIDING THE

STEP 1

STEM ON THE FRONT OF THE PUMP COVER ALL THE WAY OVER TO THE "+" SIGN. (Fig. B).

ATTACH THE INCLUDED PLASTIC FITTING INTO THE PUMP OUTLET (Fig. B) (DEPENDING ON YOUR

STEP 2

MODEL, SOME FITTINGS MAY ALREADY BE PRE-INSTALLED AT THE FACTORY)

LOCATE AND PULL THE OPEN END OF THE PLASTIC FILL TUBE OUT FROM THE OPENING IN THE REAR

STEP 3

OF THE FOUNTAIN AND PUSH IT ALL THE WAY DOWN ONTO THE PUMP FITTING. (Fig. C)

ATTACH THE POWER CORD PLUG COMING FROM THE PUMP TO THE SOCKET ON THE A.C.

STEP 4

ADAPTER. PUSH IT ALL THE WAY IN THEN SECURE THE CONNECTION BY SCREWING THE NUT ONTO

THE THREADED NECK UNTIL TIGHT. (Fig. D)

ATTACH THE L.E.D. BARREL CONNECTOR COMING OUT OF THE FOUNTAIN OPENING TO THE

STEP 5

MATING SOCKET ON THE WIRE LEAD COMING FROM THE PUMP. PUSH IT ALL THE WAY IN THEN

SECURE THE CONNECTION BY SCREWING THE NUT ONTO THE THREADED NECK UNTIL TIGHT. (Fig. E)

PLACE THE PUMP INTO THE OPENING IN THE REAR OF THE FOUNTAIN, MAKING SURE THAT THE

STEP 6

BARREL CONNECTOR (Fig. E) REMAINS OUTSIDE OF THE FOUNTAIN. (THIS CONNECTION MUST

REMAIN OUT OF THE WATER AS SHOWN IN Fig. F).

FILL THE FOUNTAIN WITH WATER. MINIMUM WATER LEVEL REQUIRES THE PUMP TO BE

STEP 7

COMPLETELY SUBMERSED. MAXIMUM LEVEL IS JUST BELOW THE LOWER EDGE OF THE

OPENING .

PLUG A.C. ADAPTER INTO GFCI OUTLET. BE SURE TO LEAVE A "DRIP LOOP" IN THE WIRE.

STEP 8

(SEE FIG. 1 ON NEXT PAGE)

HELPFUL TIPS:

1) If water does not flow shortly after power up, unplug and refer to STEP 1 to confirm

that the flow control is in the fully open position. OR Air may be trapped within the

pump. Remedy this by removing the pump & placing back into the filled basin.

2) If splashing occurs when the fountain is running, try reducing the flow rate of the

pump by sliding the stem on the front cover towards the minus (-) side. (see Fig. B)

Assembly & Operating Instructions

The following instructions will assist you in assembling , operating and maintaining your

fountain. Depending on which fountain you have purchased, there may be slight variations in how

they get assembled.

Eternity- Item # 03881

Fitting

Fig. C

Solace- Item # 03882

Fig. D

Fig. E

Fig. F