Belden Hirschmann OCTOPUS 8TX-EEC-M Instrukcja instalacji - Strona 18
Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Przełącznik Belden Hirschmann OCTOPUS 8TX-EEC-M. Belden Hirschmann OCTOPUS 8TX-EEC-M 20 stron. Ip65/67 switch
Drukuj stronę
1.3
Power supply
The supply voltage is connected by means of a 5-pin, "A"-coded M12
connector (e. g. ELWIKA 5012 PG7).
You will find more information here:
"Connecting the power supply and the signal contact lines" on page 32
1.4
Ethernet ports
You can connect terminal devices and other segments at the ports of the
device via twisted pair cables.
You find information on pin assignments for making patch cables here:
"Pin assignment OCTOPUS 8TX-EEC and OCTOPUS 8TX-EEC-M" on
page 19
"Pin assignment OCTOPUS 8TX PoE-EEC" on page 19
1.4.1
10/100 Mbit/s twisted pair port
This port is a 4-pin, "D"-coded M12 socket.
The 10/100 Mbit/s twisted pair port allows you to connect network
components according to the IEEE 802.3 10BASE-T/100BASE-TX standard.
This port supports:
Autonegotiation
Autopolarity
Autocrossing (if autonegotiation is activated)
100 Mbit/s half-duplex mode, 100 Mbit/s full duplex mode
10 Mbit/s half-duplex mode, 10 Mbit/s full duplex mode
Delivery state: Autonegotiation activated
The screw threads of the M12 ports are electrically connected to the device
casing.
1.4.2
10/100 Mbit/s PoE port
The PoE ports support the connection and a remote power supply of (for
example) IP phones (Voice-over-IP), webcams, sensors, print servers, and
WLAN access points. With PoE, these end devices are powered via the
twisted pair cable.
This port is a 4-pin, "D"-coded M12 socket.
The 10/100 Mbit/s PoE(+) port allows you to connect network components as
a powered device (PD) according to standards IEEE 802.3 10BASE-T/
100BASE-TX and IEEE 802.3af/at.
18
Installation OCTOPUS 8TX-EEC
Release 07 01/2021