CASO DESIGN HW 400 Oryginalna instrukcja obsługi - Strona 12

Przeglądaj online lub pobierz pdf Oryginalna instrukcja obsługi dla Dozownik wody CASO DESIGN HW 400. CASO DESIGN HW 400 16 stron. Instant boiling water dispenser

5.1 Before initial use

1. Place the device in a safe location and plug it in.
2. Please do not use the filter at this moment yet.
3. Fill the water tank with approximately 4 cups of water.
4. Remove the drip tray.
5. Place a large bowl in front of the device so that it collects the water that runs out of the
spout.
6. Start the device with maximum temperature setting.
7. Switch the device off, when the lamp lights in red.
8. Remove the plug from the wall outlet and let the device cool down.
9. Refill the water tank again with fresh water. The device is now ready to use.
Filter
Warning
► The filter is only intended to filter tap water. Do not use water of unknown quality or that
has been microbiologically impaired.
1. Remove the filter from all packaging. There may be a small residue of black carbon
particles in the bag or adhering to the cartridge body. This is normal. These particles are
harmless and will be washed off during the preparation process.
2. Soak the filter upright in water for 10 min.
3. Rinse the filter under running water for 10 sec.
4. The filter is now ready for use.
Please note
► The lifetime of the filter lasts about 4-6 weeks of normal use (filtering of approximately 650
cups of water in total).
► Store the replacement filter cartridges in a cool location, out of direct sunlight and away
from heat sources.

5.2 Use

1. Fill in water
1. Open the lid, fill the water tank with the desired amount of water.
2. Therefore you can also remove the water tank.
3. Close the lid.
Please note
► The water level must be less than the Max level and be at least at Min level.
12