Aeware In.k200 Podręcznik - Strona 10
Przeglądaj online lub pobierz pdf Podręcznik dla Keypad Aeware In.k200. Aeware In.k200 12 stron. Compact full-function keypads for in.xe spa systems
Również dla Aeware In.k200: Skrócona karta informacyjna (4 strony)
Drukuj stronę
instructions
Programming purge cycles
To program the purge cycles,
you must select the frequency.
During a purge cycle, all pumps
and the blower run for one
minute.
9
����
Purge cycle frequency
Press and hold Light key until
the display shows Fx, with "x"
representing the number of
purge cycles per day (up to 4).
Use Up or Down key to change
setting.
When the desired setting is
displayed, press Light key to
confi rm. A purge cycle will start
immediately.
The "Filter" indicator lights up
when a purge cycle is on.
Water temperature regulation
In a regulation cycle, the system
fi rst generates water fl ow through
the heater housing and the plumb-
ing, in order to ensure accurate
water temperature readings as
well as avoiding heater activation
in dry conditions.
After verifying pump activation
and taking a water temperature
reading if required, the system
automatically turns the heater
on to reach and maintain water
temperature at Set Point.
The "Heater" indicator lights up
when the heater is on. It fl ashes
when there is a request for more
heat but the heater has not yet
started.
in.k200
Smart Winter Mode
Our Smart Winter Mode
protects your system from
the cold by turning pumps on
several times a day to prevent
water from freezing in pipes.
The "Smart Winter Mode"
indicator lights up when the
Smart Winter Mode is on.
Cooldown
After heating the spa water to the
desired Set Point, the heater is
turned off, but its associated
pump (Pump 1 Low-speed or CP)
remains on for a certain amount
of time to ensure adequate coo
ling of the heating element, this
prolongs its useful life. The hea-
ter icon fl ashes during this time.