Aeware In.k200 Skrócona karta informacyjna - Strona 2
Przeglądaj online lub pobierz pdf Skrócona karta informacyjna dla Keypad Aeware In.k200. Aeware In.k200 4 stron. Compact full-function keypads for in.xe spa systems
Również dla Aeware In.k200: Podręcznik (12 strony)
Drukuj stronę
98
98
98
Programming
the purge / filter cycles
Programming filter cycles
Depending on system configuration the system performs either purge cycles or filter cycles.
To program the filter cycles, you must enter these parameters: duration and frequency.
During a filter cycle, pumps & blower run at high speed for one minute to purge the
plumbing. Pump 1 or CP then runs at low speed for the remaining of the cycle.
K
ey 2
(2-Pump/ Blower System)
Press Key 2 to turn Pump 2 on at high speed. Pressing a
second time turns blower on. A third press turns Pump 2 off
but leaves blower on. A final press turns blower off. A built-in
timer automatically turns Pump 2/blower off after a prede-
termined period of time, unless Pump 2/blower has been
manually deactivated first.
The "Pump 2" indicator lights up
when Pump 2/blower is on.
Light key
Press Light key to turn light on. Press a second time to turn
light off. A built-in timer automatically turns light off after
2 hours, unless it has been manually deactivated first.
The "Light" indicator lights up
when light is on.
Up/Down keys
Use Up or Down key to set desired water temperature.
The temperature setting will be displayed for 5 seconds to
confirm your new selection.
The "Set Point" icon indicates that the display shows the
desired temperature, NOT the current water temperature!
Off Mode
This mode allows you to stop all outputs for 30 minutes to
perform a quick spa maintenance.
Press and hold Key 1 key for 5 secs to activate the Off mode.
Quick press Key 1 key to reactivate the system before the ex-
piration of the 30-minute delay.
While the Off mode is engaged, the display will toggle
between OFF and the water temperature.