Consort CN2MLSTiE Instrukcja instalacji i sterowania - Strona 5
Przeglądaj online lub pobierz pdf Instrukcja instalacji i sterowania dla Grzałka Consort CN2MLSTiE. Consort CN2MLSTiE 7 stron. Wall mounted fan heater with intelligent fan control & electronic 7-day timer
Drukuj stronę
9. Set 7-day Program
An example of one day program on
PROGRAM 1
ºC
20
19ºC
10
06:00
08:00
Logic diagram for setting program on CN2MLSTiE
PROG
- SET MINUTES
- SET HOURS
- SET DAY
- SELECT DAY TO SET PROGRAM
- SELECT PROGRAM TO SET
- SET MINUTES FOR PROGRAM
- SET HOUR FOR PROGRAM
- SET TEMPERATURE FOR PROGRAM
1.
Press and hold PROG for 5 seconds to enter the
time setting.
2.
The day will be flashing.
3.
Use TEMP and MODE to navigate day, press PROG
to select day.
4.
PROG 1 will be flashing. Use TEMP and MODE to
navigate program, use PROG to select program.
5.
The minutes will be flashing.
6.
To set minutes, use TEMP and MODE to change
minutes, press PROG to set the minutes.
7.
The hour will be flashing
8.
To set hour, use TEMP and MODE to change hour,
press PROG to set the hour.
9.
The temperature will be flashing.
10. To set temperature, use TEMP and MODE to
change temperature, press PROG to set
temperature.
To add another program repeat steps 2-10.
CN2MLSTiE
PROGRAM 2
PROGRAM
22ºC
4ºC
12:00
TEMP
MODE
3
4
PROGRAM
16ºC
14:00
16:00
The CN2MLSTiE has a 7-day timer with up to 6
programming steps available for each day. In the
programming you can set a start time and a
temperature for each program.
10. Set program inactive
If you do not require the use of all 6 programs they should
be set as inactive. When in programming mode select
the program you want to make inactive and press the
TIME button. If the program is inactive the display will show
"- -:- -". To activate the program again press the TIME
button.
11. Advance mode
Press PROG from PROG mode to bring forward the next
program. To clear advance mode, press PROG.
12. Copy day function
If you require the same set of programs throughout
the week it is possible to copy all the programs from
one day to another.
To do this, when in programming mode press and
hold the TIME button and this will bring you to the
copy day mode. To select which day you wish to
copy press the PROG button and this will cycle
through numbers 1-7 on the screen, this relates to
which day you would like to copy. 1=MON, 2=TUE,
3=WED etc.
To select which day you would like to copy the pro-
grams to, use the TEMP & MODE to navigate to the
day. Once both are selected, press the time button
to copy the day. The 'To' will flash to indicate this has
been done.
13. Heat symbol on the display
Every time there is a demand for heat, the display will
show the heat icon.
-
Reduced heat output when the room temperature
is close to the set temperature - allows for almost silent
operation.
- full heat output
PROGRAM 5
PROGRAM 6
22ºC
10ºC
22:00
66001042 Iss 02
5