Aeware k-35 Series Skrócona karta informacyjna

Przeglądaj online lub pobierz pdf Skrócona karta informacyjna dla Keypad Aeware k-35 Series. Aeware k-35 Series 2 stron. For in.xe spa systems

Drukuj stronę

Troubleshooting

Hr
An internal hardware error has been detected in in.xe.
Contact dealer or service supplier.
HL
The system has shut the heater down because the temperature at the
heater has reached 119°F (48°C). Do not enter the water! Remove the spa
cover and allow the water to cool down, then shut power off and power
your spa up again to reset the system.
AOH
Temperature inside the spa skirt is too high, causing the internal
temperature in the in.xe to increase above normal limits.
Open skirt and wait until error clears.
FLO
The system does not detect any water flow while the primary pump is
running. Check and open water valves. Check for water level.
Clean filter. If the problem persists, call your dealer or service supplier.
Prr
A problem is detected with the temperature probe.
Call your dealer or service supplier.
OH
The water temperature in the spa has reached 108°F (42°C).
Do not enter the water! Remove the spa cover and allow the water to
cool down to a lower temperature. Call your dealer or service supplier if
problem persists.
rLy
The system has detected a stuck relay error in in.xe.
Call your dealer or service supplier.
UPL
No low level configuration software has been installed into the system.
Call your dealer or service supplier.
www.geckoalliance.com
9919-100806
k-35-in
series of k-35 keypads for in.xe spa systems
The Quick Reference Card provides a quick overview of your spa's
main functions and the operations accessible with your digital control pad.
Spa functions
Key 1
Press Key 1 key to turn Pump 1 on at low speed. Press a
second time to turn pump to high speed (with a dual-speed
pump). A third time turns pump off.
A built-in timer automatically turns pump off after 20 minu-
tes, unless pump has been manually deactivated first.
The "Pump 1" indicator lights up when Pump 1 is on.
With dual-speed pump, indicator will flash when
Pump 1 is on at low speed.
Key 2
Press Key 2 key to turn Pump 2 on at low speed. Press a
second time to turn pump to high speed (with a dual-speed
pump). A third time turns pump off.
A built-in timer automatically turns pump off after 20 min-
utes, unless pump has been manually deactivated first.
The "Pump 2" indicator lights up
when Pump 2 is on.
Blower k
Press Blower key to turn blower on. Press Blower Key
again to turn off. A built-in timer automatically turns blower
off after 20 minutes, unless blower has been manually
deactivated first.
The "blower" indicator lights up
when Pump 2/blower is on.
(2 Pump System)
ey