3xLogic VX-2V-MD-RIWH Skrócona instrukcja obsługi - Strona 13
Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Kamera bezpieczeństwa 3xLogic VX-2V-MD-RIWH. 3xLogic VX-2V-MD-RIWH 20 stron. Visix v-series all-in-one camera gen ii
Drukuj stronę
:
Purpose
If the camera is installed outdoors, you can use the supplied water-proof tape to protect cable connectors and
unused cables after the camera is secured to the installation surface.
Steps:
1. Tear off the yellow release paper on the back of the water-proof tape.
2. Stretch the water-proof tape to reach twice the initial length.
3. Wrap the water-proof tape around the cable connector tightly as shown in the figure below.
Note:
Make sure that all exposed wires are all firmly wrapped and concealed by the water-proof tape.
4. Press the tape firmly on both ends of the connector to make sure no water can penetrate, as shown in the
figure below.
5. Wrap the water-proof tape around the remaining unused cables tightly as shown in the figure below (some
camera models may not feature all the pictured cables).
12000 Pecos St., Suite 290, Westminster, CO 80234 | www.3xlogic.com | (877) 3XLOGIC
V-Series Camera Quick Start Guide | VX-2V-MD-RIWH
Initial Length
Stretch
Waterproof Tape Length After Stretching
Stretch the Water-proof Tape
Cable Connector
Wrap the Water-proof Tape
Press
Press the Water-proof Tape
Stretch
13