Consort PLSTi150SL Instrukcja instalacji i sterowania - Strona 2
Przeglądaj online lub pobierz pdf Instrukcja instalacji i sterowania dla Grzałka Consort PLSTi150SL. Consort PLSTi150SL 4 stron. Sl wireless controlled low surface temperature fan heaters with intellingent fan control
Drukuj stronę
2
Overview
Please read this guide carefully and retain for future
use and maintenance.
This appliance has been designed and manufactured
to the highest international standards, however, care
must be taken for optimal results and safety. This
appliance also meets the requirements of EU Directive
2004/106/EC for EMC and 2009/125/EC Directive.
Safety & Care
Our Low Surface Temperature heaters have been
designed and built to the NHS requirement for safe
surface temperatures which is that no surface which
can be touched by the user will be more than 43
degrees C (at a room temperature of 21 degrees C.)
This means that our Low Surface Temperature heaters
out-perform the European Standard by a significant
margin.
The appliance is not intended for use by persons
(including children) with reduced physical, sensory or
mental capabilities or lack of experience and
knowledge unless they have been given supervision
or instruction concerning use of the appliance by a
person responsible for their safety. Children should be
supervised to ensure that they do not play with the
appliance.
Warning
Do NOT site the appliance into a corner.
Do NOT handle the appliance with wet hands.
Do NOT use the appliance in workshops or rooms
where excessive dust is generated or present.
Ensure that nothing is pushed into the air outlet of
this appliance.
Do NOT touch outlet grille when the appliance is in
use.
Do NOT cover or restrict the appliance when in
use.
Do NOT use the appliance if damaged.
Do NOT leave the appliance unattended where
young children are present.
Connection to the Main Supply
Electrical installation should be carried out by a
competent installer, preferably registered with NICEIC
(National Inspection Council for Electrical Installation
Contracting) in accordance with the 17 edition of the
IEE Wiring Regulations, (BS.7671), and any relevant
Local Authority Bye-Laws. This heater is fitted with a 3-
core mains supply cable and should be permanently
66000959 Iss 01
connected to the electricity supply via a double pole switch
having 3mm gap on each pole.
A switched Fused Connection unit to BS.1363. Part 4 is a
recommended mains supply connection accessory to
ensure compliance with safety requirements applicable to
fixed-wiring installation.
Note: When switched on for the first time the appliance may
emit a slight smell. This is purely the evaporation of a fluid
used in the manufacturing process.
WARNING: This appliance must be earthed.
Thermally Operated Cut-Out
The appliance is fitted with a thermally operated cut-out
(TOC). This is a safety device, which switches the heater off
if, for any reason, the appliance overheats. The TOC can
only be re-set after the appliance has cooled down. In
order to re-set the TOC, proceed as follows:
Switch off appliance and leave for approximately
10 minutes.
Switch appliance back on and the TOC will re-set.
Ensure that the appliance is functioning correctly.
If the TOC control operates again, the appliance
should be checked by a competent electrician.
The heater carries a 'Do Not Cover' label to warn the user
that if the appliance is covered, there is a risk of
overheating.
Cleaning
Always disconnect the heater from the mains before
cleaning. The heater should not require any maintenance,
but it is strongly advised that it is kept clean. An occasional
wipe over with a soft cloth is all that should be necessary.
Do NOT use metal or furniture polish on any part of the
heater.
Do NOT touch the heater with wet hands or in any way
bring water into contact with it.
If the supply cord is damaged, it must be replaced by the
manufacturer or its service agent or a similarly qualified
person in order to avoid a hazard.