Constellation Altair II Instrukcja obsługi - Strona 13

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Wzmacniacz Constellation Altair II. Constellation Altair II 19 stron.

Remote control

The remote operates the basic functions of the Altair II. It does not operate other Constellation Audio

components.

19. Standby/power

Push this button to turn the Altair II on and off. When you turn the unit on, it will take a few seconds

for the power supply and preamp to warm up. When the preamp is ready for use, its LCD screen will

show the most recently selected input, and the blue LED on the front of the power supply will come

on. To put the unit in Standby mode—which will silence the audio but keep the power supply on so the

unit stays warmed up—press this button again after turning on the power.

20. Mute

Press this to button to silence the Altair II temporarily. The numerical volume readout will flash. Press

again to restore the audio. Because the Altair II uses a relay to perform the mute function, it may take

a second or so for this control to respond.

21. Volume up/down

Press these buttons to raise or lower the volume. Each press changes volume by 1 dB at volumes below

-50.0 dB, and 0.5 dB at volumes above -50.0 dB. Holding the buttons down raises or lowers the volume

quickly.

22. Balance left/right

Press these buttons to shift the balance to the left or right. Each press changes the balance by 0.1 dB.